Diamond tools or any other power tools for can be potentially dangerous if not used correctly. This short article will touch base on some of the do's and don'ts of normal diamond saw blade consumption.
Things you should check always before you begin cutting.
Ensure the stone edge does not have any damage to it (delivery or past use) before rising in your saw.
Ensure the arrow indicates the appropriate rotation direction when mounting on the saw, if you place a diamond blade on backwards the performance will be greatly reduced and you'll not get the full life from the saw blade.
Tighten the flanges (plates that hold the diamond blade about the crank shaft) to avoid the blade from slipping during the cut and to assure full cutting performance.
If you are employing a wet cutting saw, make certain the streams are clean and unobstructed to stop overheating of the scribd for blades and to clear the cut of any slurry. (cutting material left behind throughout the cutting process)
Make sure you know the proper RPM speed of the edge and use the saw accordingly.
Use respiratory safety equipment in order to avoid breathing any probably hazardrous air born dirt cause by cutting. (Even when wet cutting, it is always recommended to wear all the appropriate safety equipment)
Ensure the diamond knife still has cutting segments! All diamond knives have a welding point, whether it be laser welded or sintered there is always about 1mm of worthless portions. Examine your diamond knife regularly when you notice the pieces are nearly worn. Ideas to ensure correct cutting methods.
Ensure that your saw has proper maintennance: Always check the flanges, crank shaft (arbor), bearings, straps, filters, oil, etc.
Ensure your cutting saw's arbor shaft spins on a true axis. A canal than has any type of wobbling will greatly reduce the life span of the diamond tool.
Use light to medium pressure when cutting, enable the diamond knife to push through the material in a safe speed.
Never use extortionate force or you may overheat the stone blade or worse yet, throw a segment which can be potentially lethal considering the RPMs at which the saw runs.
Ensure that your time blade has enough diamonds protruding at first glance or it will not cut effectively. Common reason behind this is cutting a material that is way too hard for your diamond blades uk bond. You can reduce highly abrasive materials to resharpen the diamond blade, such as asphalt or abrasive cinder-block.
Make short cuts in the product you're cutting. Like, if you have to cut 4 inches deep you must cut in 2 moves. The Very First pass at 2' deep and the next pass at the total 4' depth to avoid over-heating and extend the stone blade's life period considerably.
Never work with a diamond blade for grinding materials. A diamond blade must ONLY be used to produce straight cuts, if you attempt to cut in shapes it's very possible that the diamond blade will get stuck or break a part and send it flying at dangerous speeds. In the lowest, the blade will don unevenly and overheat (considering that the diamond segments lose their width they also lose their potential to retain heat, thinner things overheat even faster)
Make sure the stone blades is not bent, this can be a danger as it could get caught in the cut and throw sectors.
Utilize the diamond blade only on materials it is specifically manufactured for. Using the wrong diamond blade on certain materials may cause segment reduction, smoothing of the segments (causing it to cut very slow and inadequate), fast use or not cut at all.
In the event that you follow these easy steps you'll save time and money through the successful usage of diamond knives and save your-self lots of grief or even injury in worst case scenarios Discover More Here.
Copyright © by the contributing authors, 2007-2024.